MKCM type AIR SIGNAL
 |
[ Flow rate with a switch ]
to detect the flow of fluid, it is turned ON or OFF the switch at your specified flow rate
※ switch is fixed (can not be set value changes later) [ flow is visible at a glance ] transparent tube of a galvanometer to check the flow of fluid in the movement of the float [ with protective cover ] by the metal protective cover the possibility of damage due to impact or the like from the outside and reduce. [Mounting orientation does not matter ] attitude of when mounting because it uses a spring inside is you can do up and down and sideways, etc. freely.
|
Model List
|
Model |
Dimensions (mm) |
Flow rate (L / min) |
|
Port size |
full length |
Full width |
Depth |
Minimum inside diameter
φmm |
Specified range of operating flow rate |
maximum |
|
MKCM20-1TA-OFF |
Rc1 / 8 |
80 |
Thirty |
twenty two |
6.5 |
1 to 40 |
300 |
|
MKCM20-1TA-ON |
|
MKCM20-2TA-OFF |
Rc1 / 4 |
80 |
Thirty |
twenty two |
6.5 |
1 to 40 |
300 |
|
MKCM20-2TA-ON |
|
MKCM20-3TA-OFF |
Rc3 / 8 |
86 |
Thirty |
twenty five |
6.5 |
1 to 40 |
300 |
|
MKCM20-3TA-ON |
|
MKCM30-2TA-OFF |
Rc1 / 4 |
104 |
43 |
32 |
9.5 |
5 to 100 |
600 |
|
MKCM30-2TA-ON |
|
MKCM30-3TA-OFF |
Rc3 / 8 |
104 |
43 |
32 |
9.5 |
5 to 100 |
600 |
|
MKCM30-3TA-ON |
|
MKCM30-4TA-OFF |
Rc1 / 2 |
110 |
43 |
32 |
9.5 |
5 to 100 |
600 |
|
MKCM30-4TA-ON |
|
MKCM35-4TA-OFF |
Rc1 / 2 |
124 |
49 |
44 |
13.5 |
30 to 150 |
1500 |
|
MKCM35-4TA-ON |
|
MKCM35-6TA-OFF |
Rc3 / 4 |
124 |
49 |
44 |
13.5 |
30 to 150 |
1500 |
|
MKCM35-6TA-ON |
|
MKCM45-6TA-OFF |
Rc3 / 4 |
142 |
62 |
Fifty |
18.0 |
50 to 300 |
3000 |
|
MKCM45-6TA-ON |
|
MKCM45-8TA-OFF |
Rc1 |
142 |
62 |
Fifty |
18.0 |
50 to 300 |
3000 |
|
MKCM45-8TA-ON |
 |
When ordering, quote □ Please specify the inside of.
Model
MKCM □□ - □ TA-OFF (ON) |
Operating flow rate of the switch □ L / Min |
Example: MKCM20-2TA-OFF operation of the switch flow rate 30L / min
※ contact method Please specify the is OFF method or the ON system.
Contact is OFF (normally open · A contact) when the OFF mode, the fluid does not flow
contact is ON (normally closed · B contact) when it is not ON system, and fluid flow standard specification
|
fluid |
gas |
|
Operating flow rate |
Above, please specify at a flow rate value within the specified range of operating flow rate. |
|
Connection |
Rc female thread |
Changes to the R male thread
combination with R male thread is also available. |
|
Heatproof temperature |
Maximum 60 ℃ |
Heat-resistant (up to 100 ℃) are also available. |
|
Breakdown |
1MPa |
The breakdown voltage specification (highest 5MPa) are also available. |
|
Maximum working voltage |
DC, AC 300V |
|
Maximum current |
DC, AC 0.5A |
|
Contact capacity |
50VA |
Material
quality |
Transparent tube |
acrylic |
Heat resistance and breakdown voltage specification product will be the brass tube (C3604).
Heat resistance and breakdown voltage specification product can not be visually float. |
|
Protective cover |
BC (gunmetal) |
Aluminum can also be manufactured. |
|
Fittings |
C3604
(brass) |
Made of SUS are also available. |
|
spring |
SUS304 |
- |
|
Magnet containing float |
Acrylic or
nylon |
You may need to use the aluminum depending on the specifications. |
|
O-ring |
Nitrile rubber |
Heat resistance and breakdown voltage specification will be the fluorine rubber. |
|
Reed switch |
Commercial goods |
- |
Lead
(standard 200mm) |
Commercial goods |
Designation of the length of the lead,
it is also possible to change to the cab tire cord. |
|
Caution on the flow switch use
1.
Notes on the magnetic impact
● reed switch, since the switch acting on a magnetic, used where not affected by the magnetic field, please.
● When the magnetic material of iron such as in the vicinity of the reed switch is present, it becomes the cause of the malfunction.
2.
Notes on the electrical connection
● flow switch, it is an over-current flows through the reed switch in the cause, such as a ground wire connection failure as no
Please note the connection.
● Please use as much as possible the alarm detector flow switch.
In conjunction with other electrical equipment if you want to use and is, on the sufficient consideration of the influence of when the malfunction occurs, please handling.
● use voltage, when used in suppressing the current used is as small as possible, the life of the reed switch is long Masu no longer.
(Usually 100V0.5A about under the circumstances 100Million times switch actuation can be used)
